here is what my set up is so far

b18 block GE sleeves 84mm
11.5:1 cp pistons 84mm
knife edged crank and balanced
manley all motor rods

b16 head ported by rlz
ferea valves
rlz springs/retainers
skunk pro 1 cams
SSR street sweeper header

i have some 310 rc injectors for this build i am just wondering if i need to go bigger or not also what kinda power should this setup make tuned on hondata s100??

 

i would use 370's if it were my motor.

 

you could most likely get away with 310's, but why chance it, go 370 and have a touch of head room so you can have one less thing to worry about while tuning.

 

370's and ull be fine. im using 440's

 

well i was asking cause i already have a set of rc 310's and i wanted to see if i needed to try to sell them for bigger or would they be enough???

 

get bigger. i have maxed out 310 on a smaller motor.