I have a set of cams. I was told that they were m24x. But after trying to degree
them I have seconds thoughts. They are marked 298F abd 37932 both on the exhaust cam no markings on the intake cam.
I will take a picture later.
Thanks in advance.

 

bump

 

What were the degree numbers? I can answer your question then.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by DonF &raquo;</TD></TR><TR><TD CLASS="quote">What were the degree numbers? I can answer your question then.</TD></TR></TABLE>

lol I highly doubt he degreed them in if he hasnt even installed them yet.

 

He does say trying to degree. That of course could mean many things. LOL

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by DonF &raquo;</TD></TR><TR><TD CLASS="quote">He does say trying to degree. That of course could mean many things. LOL</TD></TR></TABLE>

lol woops I didn't even read well....oh well....lol

w00t

 

if you have a caliper to take life measurements could help narrow it down

 

ok, here is what i have, the intake cam comes close.
Intake .050 OPEN 32BTDC and CLOSE 59ABDC

Exhaust is waaaay off.

Exhaust .050 OPEN 41BBDC and CLOSE 25ATDC

Any one have any guesses?

 

Whom did you buy these from.

I think I know where you got them from.

Thanks!

 

Check out this thread... https://honda-tech.com/forums/showth...2638209&page=2

I'm guessing that they are Schneider Cams just by the 298F marking. In which case the 37932 mark will be the Work Order number. If they are they are custom ground cams and are not S***! Schnedier Cams come from what use to be Schneider/Crower Cams. They make a great product. I emailed the owner of the company and he pulled the WO on my set and then sent me the Specs. Hope this helps

 

Guess I should have looked at the date of this thread... Duh.