Just installed my drag 3 kit...comments needed!!
Thread Starter
Joined: Jan 2002
Posts: 1,254
Likes: 0
From: West coast, USofA
Just installed my drag 3 kit...comments needed!!
On a 2000 Type-R...running at only 5 psi...plan to get a full stand alone but for now i'm not going to go over 7 psi boost. what do you guys think?? is it safe to take it to redline?? (8400 rpm)...and suggestions are very welcomed!!!!
SETUP:
Drag 3 kit
.3 bar tial waste gate
SETUP:
Drag 3 kit
.3 bar tial waste gate
Honda-Tech Member
Joined: Jan 2000
Posts: 500
Likes: 0
From: Kings Mountain, NC, USA
Re: Just installed my drag 3 kit...comments needed!! (R-1303)
First off, congratulations & welcome to the Darkside! 
I'd say once you're sure there are no leaks, not detonating, and other potential problems are taken care of ... go for it!
Avoid bouncing off the rev limiter though as that could be bad.
BTW, are you running an open downpipe now? I bet it would sound good at 8400!
I'd say once you're sure there are no leaks, not detonating, and other potential problems are taken care of ... go for it!
Avoid bouncing off the rev limiter though as that could be bad.
BTW, are you running an open downpipe now? I bet it would sound good at 8400!
Thread
Thread Starter
Forum
Replies
Last Post
Chip398193
Forced Induction
8
Jan 11, 2002 10:47 AM