trying to get rid of my built b20vtec
Thread Starter
Honda-Tech Member
Joined: Nov 2001
Posts: 5,458
Likes: 0
From: Somewhere on the West coast, USA
trying to get rid of my built b20vtec
trying to get rid of my built b20vtec swap list as follows
jdm gsr motor sleeved with darton sleeves bored to 84mm
arias 12:1 pistons
eagle rods
LS CRANK
balanced rotating assembly
R&D cnc ported head
crower stage 1 cams / or skunks your choice
ctr crank pulley - just for the winter usually have a b16a crank pulley on it for a/c
itr valve springs retainers
skunk2 manifold
dented 4-1 dc jdm
act full face with ITR flywheel
98 spec 4.78final jdm itr trans
--- AEM ECU ALSO availble, but that will have to be discussed.
stright sale im shooting for 5000$ motor has less than 20k on build it does need new valve seals SOON! i may replace them for free when the motor is out if you buy them!
for trades
DEPENDS ON YOUR SWAP!!! clean/milege etc etc
starting prices i will give on motors
2000 for b16a1 or b16a2 complete
1800 for b18b complete 200 more if b20
3000 for b18c/1 complete
5000 ASKING PRICE i know it sounds like it alot but i figure an asking price of what a JDM 98+ itr motor goes for would be a good price! motor is in the car you can test drive runs and drives GREAT!!!!
http://www.youtube.com/watch?v=Nz_JgmLC07Q
sorry for the shaking at the end road was a nasty onramp UPHILL
jdm gsr motor sleeved with darton sleeves bored to 84mm
arias 12:1 pistons
eagle rods
LS CRANK
balanced rotating assembly
R&D cnc ported head
crower stage 1 cams / or skunks your choice
ctr crank pulley - just for the winter usually have a b16a crank pulley on it for a/c
itr valve springs retainers
skunk2 manifold
dented 4-1 dc jdm
act full face with ITR flywheel
98 spec 4.78final jdm itr trans
--- AEM ECU ALSO availble, but that will have to be discussed.
stright sale im shooting for 5000$ motor has less than 20k on build it does need new valve seals SOON! i may replace them for free when the motor is out if you buy them!
for trades
DEPENDS ON YOUR SWAP!!! clean/milege etc etc
starting prices i will give on motors
2000 for b16a1 or b16a2 complete
1800 for b18b complete 200 more if b20
3000 for b18c/1 complete
5000 ASKING PRICE i know it sounds like it alot but i figure an asking price of what a JDM 98+ itr motor goes for would be a good price! motor is in the car you can test drive runs and drives GREAT!!!!
http://www.youtube.com/watch?v=Nz_JgmLC07Q
sorry for the shaking at the end road was a nasty onramp UPHILL
Thread
Thread Starter
Forum
Replies
Last Post
importboi22
Southern California (Sales)
25
Apr 20, 2007 06:31 PM
