What do i need to change an non-obd to obd-1??? I have a 90ls and its non-obd about to swap a b16a that is obd-1. What changes do have to make before the swap??? Has anyone done this change.

 

Need ob1 distributor, fuel injectors and ecu.

 

But i heard that i would need new connector plugs for everything. Isn't there a 2nd o2 sensor as well???

 

obd 2 cars have 2 o2 sensors. If you put in and obd 1 motor , just reuse your pre obd injectors and dist.

 

Well i'll give it a try then. Thanks.

 

I need help with an engine swap. I have a 93 integra ls with a b18a (Obd1) I am putting in a 1st gen JDM b16a with a Y1 tranny+LSD (Non-obd I think, not sure tho.) I am gettin the axles, ecu... the whole swap. Is Obd1 better then non-OBD? If so, how can I make the JDM b16a into an OBD1? What are the differences between the two?

 

actually u have to change alot of wiring also...

http://www.hasport.com/non-obd_to_obd1.htm

check it out... let me know how it goes..