Hello, from Memphis, TN!
Next week there is a national autocross in KS that me and fellow enthusiasts from Memphis are going, to compete. To prepare my car for the challenge I'd like to install an LSD this week. Now I've searched around a bit and found a little bit of information, but not enough to determine what parts are needed for this custom LSD installation. The engine swap in this CRX is a JDM B16 mated to the SiR S1 cable clutch type transaxle.

In my possesion is an Integra Type R LSD.

Scouring the internet I have read the hear-say that it is suggested to use a USDM GSR YS1 cable clutch type transaxle if you want to use the ITR LSD in a cable transaxle. I have also read that there are ways to fit the ITR LSD into the SiR S1 transaxle but not enough information to decipher if this will be a successful custom installation.

In autocross terms a LSD cuts seconds off of your times, which potentially wins championships. I need the advice and knowledge from someone who has made this custom LSD swap work to enable me to complete it.