I just put a d16z6 in this new 92 civic hatch cx i just picked up for cheap cause the motor was bad. Well i did the swap and the throttle response is horrible. I put in the p28 ecu and instead of getting the wiring harness out of an ex or si i just bought a buddy club v-con v-tec controller and installed it. The problem is when i open it to full throttle wile it idles it takes a while for it to rev up and if i keep my the throttle open it wont redline it just sits at about 6500 and wont go any higher. I have the stock intake of the cx still on and wiring harness but i didn't think thats what would cause the proble. Any suggestions?

 

adjust your throttle cable