Feeler:Semi Built B16 swap
Thread Starter
Honda-Tech Member
Joined: May 2004
Posts: 931
Likes: 0
From: so cal, ca
Feeler:Semi Built B16 swap
Im thinking of selling my 1st gen b16 swap. The motor was rebuilt by Planbmotorsports, where it was bought.
Head:
Stock head with skunk 2 intake manifold, and aem fuel rail.
Block:
.25 oversized ctr pistons
Greddy Header
B16 tranny with act clutch and stock flywheel
It also has Type R valve cover, and AEM intake. The motor runs very strong, and I have only put 7,000 miles on the motor since it was rebuilt. It also has a new timing belt and water pump. I have many vouches for this motor. The motor is currently still in the car. Throw up an
offer....
Pictures will be up tomorrow.
Head:
Stock head with skunk 2 intake manifold, and aem fuel rail.
Block:
.25 oversized ctr pistons
Greddy Header
B16 tranny with act clutch and stock flywheel
It also has Type R valve cover, and AEM intake. The motor runs very strong, and I have only put 7,000 miles on the motor since it was rebuilt. It also has a new timing belt and water pump. I have many vouches for this motor. The motor is currently still in the car. Throw up an
offer....
Pictures will be up tomorrow.
Thread
Thread Starter
Forum
Replies
Last Post
BrianB16A2
Honda Civic / Del Sol (1992 - 2000)
33
Nov 13, 2013 12:20 PM
anothersickhatch
All Motor / Naturally Aspirated
35
Oct 2, 2005 10:28 PM
