b16a ACT clutch help
Thread Starter
Honda-Tech Member
Joined: Feb 2006
Posts: 619
Likes: 0
From: Pa
b16a ACT clutch help
Hey guys, i got a greddy 18g turbo kit for my b16a crx with a b16 cable tranny. I was searching and found that i need a 90-91 integra clutch kit? I am going to run 8psi boost on stock engine and was wondering which ACT clutch to get (part #)? I saw the 311 ft.lb clutch and the 245 ft.lb and was wondering which is better for my setup. I mainly drive on the streets and dont want a really hard pedal so please give me some tips. Thanks, Matt
Honda-Tech Member
Joined: Mar 2002
Posts: 4,413
Likes: 1
From: Los Angeles, CA, U.S.A
Re: b16a ACT clutch help (B16-CRX)
all b seris flywheels and pressure plates and piolot bearings are interchangable
there is a throw out bearing for cable trannies and one for hydro trannies
ys1 = 92-01 clutch disk
a1, y1, s1, j1 = small spline 90-91 clutch disk
for act if you want something that will hold a ok amount a power and is not too hard would be the xtream pressure plate with the organic non puck clutch disk
the heavery duty pp is more of a stock replacement and really wont hold much power and i thin should not be used in a boosted setup
there is a throw out bearing for cable trannies and one for hydro trannies
ys1 = 92-01 clutch disk
a1, y1, s1, j1 = small spline 90-91 clutch disk
for act if you want something that will hold a ok amount a power and is not too hard would be the xtream pressure plate with the organic non puck clutch disk
the heavery duty pp is more of a stock replacement and really wont hold much power and i thin should not be used in a boosted setup
Thread
Thread Starter
Forum
Replies
Last Post
Slvr_CRX
Honda CRX / EF Civic (1988 - 1991)
10
Sep 3, 2003 12:40 PM
