can anyone verify that the fitting sizes on the ends of the AEM fuel rail is -6AN? I need to remote mount my FPR/gauge. I searched, and the only answer given was "9/16-20" and you need some kind of adapter. the AEM site just said either -6AN or -8AN.

 

I thought it was 8 or 10, pretty sure it say it right on the box

 

-6AN, 9/16-20 is the actual thread pitch on the -6AN.

If you need them, I have hundreds of them...

stan

 

Were you talking about the inlet/outlet or the spot where the factory FPR goes?

 

thanks for clearing that up stan

I was talking about the two port plugs on the ends of the rail.

 

Mine says -6AN as well.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Flamenco-T &raquo;</TD></TR><TR><TD CLASS="quote">-6AN, 9/16-20 is the actual thread pitch on the -6AN.

If you need them, I have hundreds of them...

stan

</TD></TR></TABLE>

this guy is correct.