Lets liven things up a little
Lets hear a list of all the components sitting in your room/garage/yard whatever, that will be going on your car in the near future. I'll start...
Brembo rear rotors
Hawk HPS pads
Stillen SS lines
Valvoline Synthetic fluid
Bumper guards
Brembo rear rotors
Hawk HPS pads
Stillen SS lines
Valvoline Synthetic fluid
Bumper guards
installed my fpr and cold air ducting this weekend while helping dave (4doorh22) with his clutch and flywheel install 
this weekend, ST rear sway, brembo solid rear rotars, and my new tiyarz

this weekend, ST rear sway, brembo solid rear rotars, and my new tiyarz
well on the greddy front lip are two ports or ducts can be used for anything i got from home of depot (
) 6"x8' flexible a,luminum ducting, rivited it to the back of the lip so the port on the right side of the lip gfeeds it and basically my filter is bathed now int he cold air
) 6"x8' flexible a,luminum ducting, rivited it to the back of the lip so the port on the right side of the lip gfeeds it and basically my filter is bathed now int he cold air
Trending Topics
Hmm, just cleaned my rims. Still waiting on my Greddy SP to arrive (see sig for updates) After this exhaust, I want to say I am done, but I have said that numerous times.
hmmm..........lets see, eibach prokits, tokico blues, ex header, rims, tires, axles, brembo rotors, hawk HPS, pain for moldings, and i think that should be it.
room - 4 225/50/15 Kumho V700's, drivers side axle, 3 sets of brake pads, full set of rotors, 3 quarts of high temp brake fluid, quarts upon quarts of other various fluids
car trunk - 4 Kosei K1's with Kumho Ecsta 712s on them
car interior - grease stains
car trunk - 4 Kosei K1's with Kumho Ecsta 712s on them
car interior - grease stains
CM Stage 3 Clutch, CM Flywheel, APexi RSM, Fields VTEC Controller, VIS Octane Front Bumper, Z3 Fenders, and in about 2 weeks i have the F- Max kit arriving.
B18C1 on my engine stand and all over the floor of my garage. A Tubronetics T3/T4 turbo, Spearco FMIC, turbo timer, boost gauge. Now I just need to find a car to put these in.
For the Accord I have a set of Unorthodox pulleys. They will probably never go in. I am just too damn lazy.
For the Accord I have a set of Unorthodox pulleys. They will probably never go in. I am just too damn lazy.
Thread
Thread Starter
Forum
Replies
Last Post
chitownrida
Mid-West (Sales)
1
Mar 17, 2009 07:17 PM
twisted_jdm_b16
Honda Civic / Del Sol (1992 - 2000)
3
Feb 25, 2007 04:50 PM
GSblueRacing
Acura Integra
8
Dec 21, 2004 08:08 PM




