ENDYN Breather Kit Issues!! Help
Thread Starter
Honda-Tech Member
iTrader: (1)
Joined: Jul 2002
Posts: 1,388
Likes: 2
From: Everywhere you want to be
ENDYN Breather Kit Issues!! Help
Whassup folks...
I installed an endyn breather kit a few weeks ago, and here's my issues..
1. Mounting the damn thing. As of right now it's attached with one screw on the strut tower. I've realized that I will have to drill into the strut tower or the firewall, but what should I use to hold the canister harness up?
2. I was looking to see how I could mount it, and realized that there was water in the hose exiting the bottom of the canister
. It was not a lot of water, but more than a tea spoon. I am assuming it's from condensation; however, I am scared that it will drain into the block. HELP HELP HELP. What should I do short of removing the whole thing?
(It's the hose all the way to the right)
(This is how it's connected... the hose connected at the bottom of the t.)
Modified by Touch at 7:42 PM 3/12/2006
I installed an endyn breather kit a few weeks ago, and here's my issues..
1. Mounting the damn thing. As of right now it's attached with one screw on the strut tower. I've realized that I will have to drill into the strut tower or the firewall, but what should I use to hold the canister harness up?
2. I was looking to see how I could mount it, and realized that there was water in the hose exiting the bottom of the canister
. It was not a lot of water, but more than a tea spoon. I am assuming it's from condensation; however, I am scared that it will drain into the block. HELP HELP HELP. What should I do short of removing the whole thing? (It's the hose all the way to the right) (This is how it's connected... the hose connected at the bottom of the t.)Modified by Touch at 7:42 PM 3/12/2006
Thread
Thread Starter
Forum
Replies
Last Post
prelude-all-the-way
Welding / Fabrication
7
Jan 12, 2009 09:54 AM
FGcivic
Honda Civic (2006 - 2015)
1
Feb 1, 2007 09:08 AM