Looking for a b18a or b18b sleeved block. I dont care if it bare or complete as long as it has low miles or new. I need it for boost so if it complete then it has to be low compression. Let me know what you got. Cash in hand.

 

still looking.....this cash burning a hole in my pocket

 

damn no one needs $$$

 

bump

 

need something by tuesday

 

not one reply??? wtf???

 

still looking

 

 

I have a built B16A. Resleeved with Darton Sleeves, JE Pistons 9:1 Compression, Eagle H-Beam Rods, Eagle LS Crank, ACL or King Bearings. Motor Bored to 84mm, Stroked to 89mm. Motor blueprinted and balanced. All work was done by ARI, out of Jupiter FL. $1800.00. All parts cost $2500 and machine/assembly work cost $1800. Never been run with this set up.

Thanks

 

I need a b18 block, I'm going nonvtec. I can only use b18a/b/c blocks. But thank you for the offer.

 

cool. good luck

 

i guess i should post that i found one already huh.