Well I was driving along yesterday just fine and then I hear this rattling sound so I get out and check my header and only one of the bolts is there where it goes from 4 into 2. Does anybody know the specs on the nuts and bolts I will need to get. The one bolt that was there doesn't even thread right so I'll need to get 3 new nuts and bolts.

It's gonna be awhile before I invest in an RMF Header so I need to get this while I wait...

 

No offense - but, wouldn't you think the best person to contact would be DCSports?

 

Ya I was going to tomorrow but I wanted to get this done tonight and DC Sports isn't open right now.

 

.....hm, go to the site and see if they have install instructions. They might list the bolt sizes and thread pitch there.

 

Tried that no luck

Gonna look again anyway...

BUMP!

 

Wonder if OEM studs and nuts will work? I could go rob my parts car.

Anybody know?

 

if you have them laying around, just try it.

 

if its a nut and a bolt then why does it matter, just get two matching nuts and bolts that will fit through the hole...

 

I'm not sure.. but I think you need 14's for both

 

Well I got in touch with DC Sports today and I just thought I'd put this info on here incase anybody is searching for it later on.

M10x1.25x20

 

hey just for the advice do some research read the faq's take one of you bolts off at home depot and match it up.