i have a b16a2 with skunk2 stage2 cams and cam gears. could i put a turbo on or are the cams to aggressive?

 

Sorry not to anwser the q, but what compression r u running as well?

 

10.2:1

 

It could be done. I wouldn't push no more than 7 psi, good luck with tuning though

 

is it worth it or should i get turbo cams? and lower my compression

 

stock valve springs and retainers? ud be able to pull it off with a real nice tune..

 

omni power valve springs. i was looking for more boost out of it

 

did u check piston to valve clearance yet? the cam shouldnt be too agressive with those valve springs.. however with 10:1 compression ur gonna be deffinately needing some dyno time.. u figure if u were to sell ur cams to make the money for the turbo cams ur gonna still eventually pay for dyno tuning..

 

which cams would be better?

 

I personally wouldn't run Skunk stage2's in B16 w/stock compression in N/A form, as they're not going to reach their full potential w/such low compression.
In a turbo application, I'd sell the stage 2's and pick up a set of CTR cams.

 

cant go wrong with oem honda