IAB and knock sensor??????
Thread Starter
Joined: Jun 2004
Posts: 10
Likes: 0
From: rancho, ca, usa
IAB and knock sensor??????
i just did a OBD2 gsr into a EG obd1.... i ran a p72 obd1 computer... i need to wire up the knock sensor and IAB? is this corect if so where do i find these sensors and where do i run the wires to, the computer or harness or what? if you guys could show me pics id BE VERY HAPPY!!!!
Honda-Tech Member
Joined: Jun 2004
Posts: 150
Likes: 0
From: Portland, Oregon
Re: IAB and knock sensor?????? (jdmcraig)
http://tech.hybridgarage.com/t...18EG6
Knock Sensor - On the back of the block under the Intake manifold
IAB - On the bottom of the intake manifold. If I remember on my eg I only had to run a wire to the harness for the IAB as the factory interior harness had a wire connected to A17. I could be wrong. I only remember bringing the knock sensor wire into the firewall.
Knock Sensor - On the back of the block under the Intake manifold
IAB - On the bottom of the intake manifold. If I remember on my eg I only had to run a wire to the harness for the IAB as the factory interior harness had a wire connected to A17. I could be wrong. I only remember bringing the knock sensor wire into the firewall.
Thread
Thread Starter
Forum
Replies
Last Post
