Few questions
First what do you think power wise i'm pushing with the following setup.
1999 JDM b18c5 block
1995 JDM B18c head(fully built by crower)
Crower Titi springs/retainers
CTR Cams
ITR Cam gears.
Crower Intake valves/exhust valves
Stock bottem end
Skunk2 intake manifold /w hondata gasket
Megan J spec 4-1 race headers
2.5' testpipe
2.5' Apexi N1 cat back
excedy Stage 2 Clutch
JDM B18C tranny
Hypertech Ground kit
NGK Plugs/Wires
B18c3 dizzy
Crome tuned ecu by myself..
Round about idea..

Secondly.. I'm looking for a few answer to what's next, i'm looking at some cams, but i wanna know if some Stage 3's can work with my motor, i know stage 2's would be ideal but i rev this thing to 9300 already.. and it's supported this reving, and hardtimes for quite sometime...
I wanna know if 2.5 exhust is too big for this motor, spinning high rpms like this?? and what should i do motor wise.. any ideas??

 

skunk2 pro1's, or rm m22xx's, get rid of that header and get an anr, or rmf with merge collector, and a 65mm tb. @.5 inch exhaust is just fine. Retune and enjoy