TW: 1994 Integra RS JDM front
Thread Starter
Junior Member
Joined: Jun 2004
Posts: 540
Likes: 0
From: San Diego, CA, USA
FS: 1994 Integra RS JDM front
Hey Guys,
Testing waters on my long time love, but now I'm thinking about letting it go because I really really need to pay off by debts.
Anyhow, I'll list what goes with the car.
Engine:
B16a
Spoon Sports .25 oversized CTR pistons
Spoon Sports 2 ply headgasket
Spoon Sports magnetic drain plugs
Spoon Sports cam gears
Spoon sports radiator cap
Spoon Sports flywheel
99 GSR intake cam
All new honda bearings on every single rotating part
Crank has been micropolished and balanced
Rods have been shot peened ( I think that's how you spell it)
All new honda gaskets
AEM fuel pressure riser
ITR intake manifold
DC Sports 4 2 1 ceramic headers
I will throw in a JDM ITR 4 1 headers for extra $
Light weight crank pulley
Greddy Exhaust system cat back
MSD 6aL ignition system
Crane ignition coil
Exedy clutch
B&M fuel pressure gauge
All new Clutch master cylinder
SKunk 2 titanium retainers
PortFlow inner valve springs
ITR outer valve springs
Interior:
Black JDM ITR recaro seats
JDM ITR gauge cluster
JDM ITR center console w/ plate
JDM ITR red stichted shift boot
Spoon Sports shift **** silver
Spoon Sports VTEC controller
P63 Integra ECU
Full black interior
JDM ITR floormats
JDM ITR clock block off plate
JDM ITR pedals
Spoon sports rear strut tower bar
Exterior:
JDM ITR front end all metal
CW ITR paint paint job (all door jams and under the hood)
JDM ITR rear spoiler
JDM ITR rear tail lights
JDM ITR side markers
JDM ITR side stickers and rear sticker
JDM ITR rear registration sticker
JDM ITR front/rear emblems
JDM ITR blue vin plate in engine bay
Rollers:
16 inch gold sparco rims
power slot front brake rotors
hawk brake pads ( will throw in some endless NA sport brake pads for extra $)
brand new left side rear hub/wheel bearing
I will also include a full set of Energy suspension master kit for extra $
Vehicle is set up for rally at the moment, I just never got around to doing it
Tokico blues gas replacements
front strut tower bar that I got from a friend
Skunk 2 front upper control arms
Overall:
the car is pretty fast when VTEC kicks in however, right now I'm running a LS tranny for the highway. I never got around to setting the fuel pressure correctly. I was going to swap out the stock fuel pump for a better flowing one and some injectors. I had a ITR ECU, but I sold it cause I needed some money.
Car is located in Socal.
Here are the pics:
*Note
The front end that you see in these pictures are of the fiberglass kit that was on my car about 6mos ago. It now has a all metal black front end on it now. I haven't had the time to get it painted. I'll leave that up to you guys to deal with. If I sell it, it will be as is.
Please, Socal Folks only! If you are serious, I will talk with you. I apologize to the guys I have received emails from, but your response to me is something I can't arrange for. As far as pics, I will try to get more. I am just way too busy. I just want the car to be sold. Thanks for understanding.
LMK: Jspecjay@gmail.com
Thanks Guys
SOLD!!!
Modified by Jdmspooge at 9:43 AM 9/6/2005
Modified by Jdmspooge at 6:56 PM 9/25/2005
Modified by Jdmspooge at 2:00 AM 3/3/2006
Testing waters on my long time love, but now I'm thinking about letting it go because I really really need to pay off by debts.
Anyhow, I'll list what goes with the car.
Engine:
B16a
Spoon Sports .25 oversized CTR pistons
Spoon Sports 2 ply headgasket
Spoon Sports magnetic drain plugs
Spoon Sports cam gears
Spoon sports radiator cap
Spoon Sports flywheel
99 GSR intake cam
All new honda bearings on every single rotating part
Crank has been micropolished and balanced
Rods have been shot peened ( I think that's how you spell it)
All new honda gaskets
AEM fuel pressure riser
ITR intake manifold
DC Sports 4 2 1 ceramic headers
I will throw in a JDM ITR 4 1 headers for extra $
Light weight crank pulley
Greddy Exhaust system cat back
MSD 6aL ignition system
Crane ignition coil
Exedy clutch
B&M fuel pressure gauge
All new Clutch master cylinder
SKunk 2 titanium retainers
PortFlow inner valve springs
ITR outer valve springs
Interior:
Black JDM ITR recaro seats
JDM ITR gauge cluster
JDM ITR center console w/ plate
JDM ITR red stichted shift boot
Spoon Sports shift **** silver
Spoon Sports VTEC controller
P63 Integra ECU
Full black interior
JDM ITR floormats
JDM ITR clock block off plate
JDM ITR pedals
Spoon sports rear strut tower bar
Exterior:
JDM ITR front end all metal
CW ITR paint paint job (all door jams and under the hood)
JDM ITR rear spoiler
JDM ITR rear tail lights
JDM ITR side markers
JDM ITR side stickers and rear sticker
JDM ITR rear registration sticker
JDM ITR front/rear emblems
JDM ITR blue vin plate in engine bay
Rollers:
16 inch gold sparco rims
power slot front brake rotors
hawk brake pads ( will throw in some endless NA sport brake pads for extra $)
brand new left side rear hub/wheel bearing
I will also include a full set of Energy suspension master kit for extra $
Vehicle is set up for rally at the moment, I just never got around to doing it
Tokico blues gas replacements
front strut tower bar that I got from a friend
Skunk 2 front upper control arms
Overall:
the car is pretty fast when VTEC kicks in however, right now I'm running a LS tranny for the highway. I never got around to setting the fuel pressure correctly. I was going to swap out the stock fuel pump for a better flowing one and some injectors. I had a ITR ECU, but I sold it cause I needed some money.
Car is located in Socal.
Here are the pics:
*Note
The front end that you see in these pictures are of the fiberglass kit that was on my car about 6mos ago. It now has a all metal black front end on it now. I haven't had the time to get it painted. I'll leave that up to you guys to deal with. If I sell it, it will be as is.
Please, Socal Folks only! If you are serious, I will talk with you. I apologize to the guys I have received emails from, but your response to me is something I can't arrange for. As far as pics, I will try to get more. I am just way too busy. I just want the car to be sold. Thanks for understanding.
LMK: Jspecjay@gmail.com
Thanks Guys
SOLD!!!
Modified by Jdmspooge at 9:43 AM 9/6/2005
Modified by Jdmspooge at 6:56 PM 9/25/2005
Modified by Jdmspooge at 2:00 AM 3/3/2006
Trending Topics
Honda-Tech Member
Joined: Mar 2005
Posts: 2,263
Likes: 0
From: Portland Oregon
Re: TW: 1994 Integra RS JDM front (DA9ls-vtec91)
Hey could I get some more pics?... JDMITRTURBO@Hotmail.com
Thread
Thread Starter
Forum
Replies
Last Post
simplyrob
Vehicles for sale
42
Sep 28, 2008 03:31 PM