one of my friends B-Day is coming up and she is trying to modify her GSR. She has an exhaust on hold and i wanted to get her a header. But i dont know what header will work well on a GSR. Does the crossmember need to be notch with a 4-1 unit if so i can just get her a 4-2-1 since she doesnt really drive the car like it needs to be. She will also lower the car later so do yall think a 4-2-1 will be the best bet. It will probly be a DC sport header

 

bump

 

4-1 is better for top end. The 4-1 does sit a little lower than the 4-2-1. Mine is all scraped up from the botoming out (I am dropped 2" front 1.75" rear) but I like it's performance. You'll get a better mid range with the 4-2-1.

 

i have dc sports 4-2-1 headers on my car now and i have very good response low and high
going tubro and selling them soon though

 

but will any other moddification be needed to fit the 4-1. Like on my DA if you run a 4-1 header the crossmember needs to be notch to fit it. Ill problly get a 4-2-1 since it gives better ground clearance and when we were dating she used to freak out when i would bottom out in my car. Thanks

 

Not on a 95'.

 

an-r header....nuf said....

 

GReddy is nice for a gs-r too, try to match up with the brand of exhaust shes getting...

 

she said she was gonna get a Greddy BUT i talked to her a few days ago and she said she didnt know if she was gonna get the Greddy anymore since its kinda expensive. She might either get a tsudo system since its 2.5in piping and mandrel bent and a buddy of mine has one on his accord and its a good system.l If not that shell do a custom exhaust at a muffler shop with her choice of a muffler, maybe megan racing

 

I have the 4-1 on my 95 gsr its harder to install then the 4-2-1 if she isn't worried about performance go with the 2 piece 4-2-1 header

 

comptech!

 

I like my RS-R 4-2-1

 

I've got the DC 4-2-1 and works nice.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by SpoonSirG &raquo;</TD></TR><TR><TD CLASS="quote">I've got the DC 4-2-1 and works nice.</TD></TR></TABLE>

no complaints here.

 

i like the DC too but she wants one that has more "Bling" to it than a ceramic DC. I know the Dc can be gotten stainless steel. how much are the RS-R's and comptechs? im not looking to spend all that much but i do want to get her a well made and producing header. so far iv determined it has to be 4-2-1, have "bling" and not to terrible expensive

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by SpoonSirG &raquo;</TD></TR><TR><TD CLASS="quote">I've got the DC 4-2-1 and works nice.</TD></TR></TABLE>

still working after 5 years with no problems.