i searched and found that buddy club recommends valve lash of .008 and .009 for the spec 3+ cams. what did you guys use for valve lash with these cams? i was under the impression that these are stage 1 cams, so i was assuming lash should be set at stock specs

 

i used the recommended valve lash of .008 and .009

 

I used .008 and .009 as well. So good so far.

 

did you guys upgrade the valvetrain as well? or will itr valvetrain be enough for stock rev limit?

 

i used itr outters/portflow inners. so if your only going to the stock rev limit, your should be fine...