Hey guys, im just wondering how you all think a b16 head that has been P&P to NA specs and milled .012 will work on a boosted setup? Im asking because i plan on doing an all motor build, and then a couple years down i wanna put a k series into my eg, and chace the all motor setup into a boosted setup in my teg.... And obviously i will use the head that i alread have.

so what fo you all think?? Im guessing i can compensate with lower CR pistons for the milled head, but is this ideal or less than ideal, or is compression compression, and as long as i end up with the right CR at the end of it it doesnt matter???

ok guys;.... enlighten me please!

 

hello??? anyone???

 

bump

 

my head was milled .025 and i'm boostin

 

my friend made 260whp on his ported "NA" b16 head...turbo'd and made 730whp. So yes u can use it.