My nologys are melting sitting on the valve cover, anyone have any solutions, already searched, elec tape (melted through), different brands of wires??? Any suggestions helps, thanks.

 

Go back to stock wires and use the supplied wire holders?

 

I have the wire holders from nology and they hold the wires right on top of the valve cover . Wouldn't using stock wires be a step back wards? Also my motor doesn't have the little cover that goes over the wires. Are there any aftermarket wires that would fit under that?

 

aren't the nology wires the ones with the ground straps attached to them?

 

yea, those SOB's

 

dumb question, but are they grounded properly?

 

Yea they are grounded right but I dont think that would cause them to melt

 

only other thing i can think of is to put a set of stock ones in there and see if the same thing still happens