Posted this in the OFFICAL THREAD, but i got no response and this was 4 day's ago. Figured i'd get a quicker response if i made a thread on it.

When doing the Auto to Manual tenisor swap. It is recommended to use/get the h23 Balancer Belt pulley, but is not needed. 2point6 says you have to space it out. The Timing Belt tensior and the balancer belt pulley, pulley's should NOT being touching.. Well i've got (2)Hondpart# 90501-MB7-610 WASHERs (10.3X25) And i still think they might be touching by a little bit..

My question is would running( (3) of these washer be too much? I am not running the balancer shaft belts btw.