Got bored and took some pics of my dirty hatch-bizzle
Had some time to kill, so I went out and shot some photos with the new duckbill. Here's how I roll in the Winters here


















Wth is that red stuff? Is your motor bleeding ?
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by MiKeAhOwSkI »</TD></TR><TR><TD CLASS="quote">
</TD></TR></TABLE>
Trending Topics
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by SPNFEDEJ »</TD></TR><TR><TD CLASS="quote">good ****</TD></TR></TABLE>
what kinda wheels do you normally roll ?
what kinda wheels do you normally roll ?
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Collateral »</TD></TR><TR><TD CLASS="quote">Wth is that red stuff? Is your motor bleeding ?
</TD></TR></TABLE>
Block was painted with some crazy thick paint from the previous owner. I got some off, but I need aircraft remover for the rest.
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by JforJonathan »</TD></TR><TR><TD CLASS="quote">what kinda wheels do you normally roll ? </TD></TR></TABLE>

this baby will be slammmmmed come summer time too.
</TD></TR></TABLE>Block was painted with some crazy thick paint from the previous owner. I got some off, but I need aircraft remover for the rest.
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by JforJonathan »</TD></TR><TR><TD CLASS="quote">what kinda wheels do you normally roll ? </TD></TR></TABLE>

this baby will be slammmmmed come summer time too.
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by sleepyzze110 »</TD></TR><TR><TD CLASS="quote">i heard you needed modification to the gsr door panels to fit the gsr dash in a 92-95 hatch, how much work was it?</TD></TR></TABLE>
Bump for a write up.....
Bump for a write up.....
I bought the car with the dash and doors already in it, but the guy actually cut the door at the top where it is too wide to slide the edge of the door panel over.
Then he just drilled new holes in the door and put machine screws in through the stock holes on the door panel.
there is about a 1 inch gap at the end of the panel towards the rear of the car, but it's pretty much unavoidable.
hope that helps
Then he just drilled new holes in the door and put machine screws in through the stock holes on the door panel.
there is about a 1 inch gap at the end of the panel towards the rear of the car, but it's pretty much unavoidable.
hope that helps
yo u mind if u can take a picture under the car... i want to see how the piping is under the car.. i want my exhaust to slant too. thankz...
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by DnB TeK »</TD></TR><TR><TD CLASS="quote">sweet ride
like da interior/dash conversion, clean installed
</TD></TR></TABLE>
Really Clean!!
like da interior/dash conversion, clean installed
</TD></TR></TABLE>Really Clean!!


