Bosch LapSim: Anybody have a base ITR Parameter File?
Thread Starter
Honda-Tech Member
Joined: Dec 2000
Posts: 5,108
Likes: 0
From: Denver, CO, USA
Bosch LapSim: Anybody have a base ITR Parameter File?
I'm looking to play around with the Bosch LapSim program. Does anybody else that uses this have a vehicle parameter file for an ITR that they have set up? Just looking for a starting point to modify rather than building one from scratch. Thanks.
Honda-Tech Member
Joined: Jan 2000
Posts: 1,771
Likes: 1
From: Charlotte, NC, USA
Re: Bosch LapSim: Anybody have a base ITR Parameter File? (Flux)
I remember "descartesfool" had a post or two discussing modeling his ITR in LapSim.
I thought there was an issue with modeling the rear trailing arm with the program (ie. there's no way to do it); that might have been Suspro3D, though. I'm only familly with the ADAMS software so I can't help you.
I thought there was an issue with modeling the rear trailing arm with the program (ie. there's no way to do it); that might have been Suspro3D, though. I'm only familly with the ADAMS software so I can't help you.
Thread
Thread Starter
Forum
Replies
Last Post
