Just had my B&M short shifter installed today and the shifter was hitting on something so i took out the one of the plastic hangers . It now shifts perfectly but the piping lowered down a little bit. When I tried to go down our garage i felt the scraping underneath and it was the shifter. Should i be concerned about this that some major damage would be done due to the scraping?

 

any solution to this? i want to keep my short shifter but i dont want to scrape everytime. plus my car isnt that low too


Modified by 1cleanEJ8 at 4:00 AM 1/31/2005

 

its prolly hitting the exhaust, get a smaller resonator if its right below the shifter, or make it hang lower by modifying the exhaust hangers.

 

thanks. i'll try and do this since i just had my ITR exhaust installed too. might be the piping tha came with it