FS: 1992 Honda civic si w/b18c swap....Columbus, Ohio
1992 Honda Civic Si hatchback blk/gutted interior
Mods i do have a vin upon requst....Title is clean!
267K miles on the chassis
Exterior:
-Vis carbon fiber hood (sparco hood pins not installed)
-Vis carbon fiber rear spoiler (Spoon knockoff)
-15"x6" Rota slipstreams (flat black) w/ Yokahama avs100 70%
-Goodridge brake lines
-Hawk HP+ pads (frt) Axis pads (rr) w/all new rotors
-TCI cv axles
-Tokico blue struts w/neuspeed race springs
-Spoon rear stut tower and Neuspeed frt bar
-Energy suspension kit (about 75% of kit installed, but have the rest)
-OEM optional frt chin spoiler (thanks eeepee)
-OEM optional moonroof visor (thanks loworbit)
Black exterior. It has a couple rust spots (have pics rear quarters and a scuff on drivers door)
Interior
-4 Point Roll cage w/ harness bar. Needs welds finalized
-Stripped interior from the dash back
-OEM Type R floor mats
-Recaro SRD seats (red) w/custom sliders
-G-Force 4 point harness
-OEM optional audio console
Under the hood:
Headwork:
-Port & polish w/ five angle valve job
-Skunk2 intake manifold port matched to the head
-Hondata intake manifold gasket also port matched to the head
-AEM Type R CAI
-Spoon 70mm throttle body
-AEM fuel rail
-AEM fuel pressure reg
-RC 310cc injectors
-Venom fuel pump
-Comp Cams Stage2 (278intake 302exhaust)
-Comp Cams springs and retainers (dual springs on both sides)
-AEM 3 bolt cam gears (Have Spoon Cam gears yet to be installed)
-GReddy timing belt
-ARP head studs w/ OEM Honda head gasket
-DC Sports 4to1 header
-Gutted OEM cat converter
-Apexi N1 catback exhaust
The block:
-Block bored over fit the Civic Type R pistons w/ OEM rings (25 thousands over)
-Crank micorpoilshed
-Rods where shot peened, cleaned up of all the rough edges
-ARP rod studs
-Moroso aluminum race oil pan and pickup
-PCX oil filters
-Crank pulley was cut down to only a two belt pulley
The entire bottom was rotated and balanced (first with the crank, then crank and rods, then the entire assy, including the clutch and pressure plate)
Everything including the head and block have all new gaskets, pumps, etc.
Management:
-GReddy Emanage w/ injector harness and ingntion harness
-P72 (jdm gsr) or P28 both chipped with the mugen program 5700to9500
-GReddy wide band O2 sensor
-GReddy water temp and oil temp gauges
-GReddy temp gauges attachments (oil and water)
-MSD digital 6 ignition w/ two step
Misc:
-Spoon overflow socks (clutch and master cylinder)
-Fluidyne aluminum radiator (Civic sized)
-Denji projectors w/catz yellows
-Greddy (trust) shift ****..Also have a polished spoon ****
-neuspeed short shifter
Would like to get $8500 but am open to offers.
Don't flake or low ball me.
Have an entire book of receipts and dyno charts of this car!
The motor currently has 2800 miles on the build, recent dyno was 196hp w/143ftlbs. Still has alot of room for improvement!
I think thats everything. If you have any qustions or want pics i could get them for serious offers.
If you have a decent offer or would like pics shoot me a PM or email me at boneshonda@hotmail.com
Modified by JBONES at 3:38 PM 11/24/2004
Mods i do have a vin upon requst....Title is clean!
267K miles on the chassis
Exterior:
-Vis carbon fiber hood (sparco hood pins not installed)
-Vis carbon fiber rear spoiler (Spoon knockoff)
-15"x6" Rota slipstreams (flat black) w/ Yokahama avs100 70%
-Goodridge brake lines
-Hawk HP+ pads (frt) Axis pads (rr) w/all new rotors
-TCI cv axles
-Tokico blue struts w/neuspeed race springs
-Spoon rear stut tower and Neuspeed frt bar
-Energy suspension kit (about 75% of kit installed, but have the rest)
-OEM optional frt chin spoiler (thanks eeepee)
-OEM optional moonroof visor (thanks loworbit)
Black exterior. It has a couple rust spots (have pics rear quarters and a scuff on drivers door)
Interior
-4 Point Roll cage w/ harness bar. Needs welds finalized
-Stripped interior from the dash back
-OEM Type R floor mats
-Recaro SRD seats (red) w/custom sliders
-G-Force 4 point harness
-OEM optional audio console
Under the hood:
Headwork:
-Port & polish w/ five angle valve job
-Skunk2 intake manifold port matched to the head
-Hondata intake manifold gasket also port matched to the head
-AEM Type R CAI
-Spoon 70mm throttle body
-AEM fuel rail
-AEM fuel pressure reg
-RC 310cc injectors
-Venom fuel pump
-Comp Cams Stage2 (278intake 302exhaust)
-Comp Cams springs and retainers (dual springs on both sides)
-AEM 3 bolt cam gears (Have Spoon Cam gears yet to be installed)
-GReddy timing belt
-ARP head studs w/ OEM Honda head gasket
-DC Sports 4to1 header
-Gutted OEM cat converter
-Apexi N1 catback exhaust
The block:
-Block bored over fit the Civic Type R pistons w/ OEM rings (25 thousands over)
-Crank micorpoilshed
-Rods where shot peened, cleaned up of all the rough edges
-ARP rod studs
-Moroso aluminum race oil pan and pickup
-PCX oil filters
-Crank pulley was cut down to only a two belt pulley
The entire bottom was rotated and balanced (first with the crank, then crank and rods, then the entire assy, including the clutch and pressure plate)
Everything including the head and block have all new gaskets, pumps, etc.
Management:
-GReddy Emanage w/ injector harness and ingntion harness
-P72 (jdm gsr) or P28 both chipped with the mugen program 5700to9500
-GReddy wide band O2 sensor
-GReddy water temp and oil temp gauges
-GReddy temp gauges attachments (oil and water)
-MSD digital 6 ignition w/ two step
Misc:
-Spoon overflow socks (clutch and master cylinder)
-Fluidyne aluminum radiator (Civic sized)
-Denji projectors w/catz yellows
-Greddy (trust) shift ****..Also have a polished spoon ****
-neuspeed short shifter
Would like to get $8500 but am open to offers.
Don't flake or low ball me.
Have an entire book of receipts and dyno charts of this car!
The motor currently has 2800 miles on the build, recent dyno was 196hp w/143ftlbs. Still has alot of room for improvement!
I think thats everything. If you have any qustions or want pics i could get them for serious offers.
If you have a decent offer or would like pics shoot me a PM or email me at boneshonda@hotmail.com
Modified by JBONES at 3:38 PM 11/24/2004
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Wesb18DB8 »</TD></TR><TR><TD CLASS="quote">any pics....i have a 97 4dr gsr, leather...would u trade?.....it's in great condition...
</TD></TR></TABLE>
yeah i have plenty pics....I will send them out tonight if you have a email i could shoot them too
Also do you have pics of your 97gsr...could you send them too bondahonda@hotmail.com
</TD></TR></TABLE>yeah i have plenty pics....I will send them out tonight if you have a email i could shoot them too
Also do you have pics of your 97gsr...could you send them too bondahonda@hotmail.com
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by allmotrjdm »</TD></TR><TR><TD CLASS="quote">pics?</TD></TR></TABLE>
Tried to send pics to the email in your profile....Didnt work!
Tried to send pics to the email in your profile....Didnt work!
Trending Topics
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by SlowJim »</TD></TR><TR><TD CLASS="quote">bump for a fellow ohiohondas member
</TD></TR></TABLE>
Thanks jim!!!
</TD></TR></TABLE>Thanks jim!!!
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by SlowJim »</TD></TR><TR><TD CLASS="quote">bump for a fellow ohiohondas member
</TD></TR></TABLE>
GL
</TD></TR></TABLE>GL
Late night bump for JBONES.
Throw on a good header and get someone who can do some magic with the Emanage and it'll be 200+ WHP. It also has a helluva bite when downshifting to 3rd on the highway.
Throw on a good header and get someone who can do some magic with the Emanage and it'll be 200+ WHP. It also has a helluva bite when downshifting to 3rd on the highway.
can u send pics to Tankdogg08@aol.com thanks
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by 1700anddroping »</TD></TR><TR><TD CLASS="quote">for get the offer,good luck on sale.
</TD></TR></TABLE>
All right sorry it didnt work out! Still for sale
</TD></TR></TABLE>All right sorry it didnt work out! Still for sale


