i read on the site that they have a lope at the idle. is there any way to get rid of the lope at idle? will these cams idle rough? i want to put these cams into my car and want to know if they are worth the money and if they have nice torque even untuned.

 

have not installed mine yet but i've read by just idleing at around 900-1k will even the idle right out. cant wait to install mine.

 

ive done a lot of research on the crowers. havent installed mine yet but yes they do idle rough below 1000 rpm's.

 

forgot to ask but what management to you plan on using to tune it?

 

i love my 404's, the idle is kinda rough, but what do u expect....

 

just do it, it's not even that bad at ALL

 

when u sit in a f-body with a nice cam your whole body moves with the idle .... if they mind it u shouldn't mind on your ls motor i'd say intsall em and have alot of fun with em

 

what did you guys set your valve lash at on the 404's? Im about ready to install some.

 

mess with the air/idle screw on the throttle body...........that will take care of most of idleing problems....had mine set at 900rpm, these cams are fun even untuned, but tuning helps(of course).

 

For everyone that already has them installed. Whats your set-up, where in the powerband does it pull the hardest? Im about to pick-up some 404's for my b20 and just trying to get some reviews from the actual owners. Thanks.

 

random bump !!!

 

I love mine, pulls hard after 4k............nice steady idle.....I am selling them too to go f/i......$300 shipped to anyone

 

depends on how much overlap u run with theses cams, the more u run, the worst it will idle. i have my cams at 0,0 now and it idles like stock, i had them at +2,-2 it was noticeably faster, but it idled alil worst on cold startup

 

nonvtec.com
best site for us ls and b20 guys