Block posting. Anyone done it? Had it done? Or know about the effectiveness of it?

 

Whoa...I don't think anyone has done block posting for a while. With the introduction of efficient block guards and tough aftermarket sleeves, block posting has all but disappeared.

Search for it...I know I've seen topics on it around here. Be sure to search archived folders.

 

go to homemadeturbo.com and check out there tech page and there's a write up on it.

 

Yeah, that's where I heard about it. I couldn't find anything about the results of it on their page though. Judging by the rate it is updated I didn't think I would get a reply from the creators either. I'm building a CRX sleeper with stock motor, not looking to throw any big numbers around. I don't plan to run more than 12 psi after I strengthen the internals and the block. Until then probably around 6 psi, it'll be a SoloII car after I'm finished. So I'm not concerned with big numbers so much as just giving the old D series a little more pep around the corners.