I'm trying to replace my car's blower motor assembly, and to do this I need to remove my car's ECU bracket. I can't remove it without unplugging the wires leading into what it's housing, though, and I'm at my wit's end trying to get those plugs to come out. What is the intended method? Just pinching the connector and pulling? Is there any more nuance to it than that? Any help would be appreciated.

 

From what I remember and the bad picture I was able to find.......

Undo the four bolts holding the assembly and loosen it. Reach underneath to "pinch the connector tab" and use the assembly to pull on.

 

Thank you so much!