Ok so I have a 95 accord coupe 4cyl and I purchased a front bumper for a 94-95 accord. No the only difference I thought was between the 4cyl and the 6cyl but I tried to install the turn signals and they are way to big like not like I can sand down edges like it's not ment to fit. Anyone else have this problem is there a difference in the 4door and 2 door fronts??

 

96-97 Accords have wider turn signals than the 94-95 Accords by a good amount. You sure yours isnt a 96?

 

96-97

94-95

No... there's no difference between the 2dr and 4dr
And yes, in terms of fitment the 4cyl coupe's and sedan's front bumper covers are interchangeable. As stated above the only differences are in the years. So someone most likely gave you the wrong part..? Iirc the 6cyl and wagon covers are a bit longer where it lines up with the fenders, from the headlight/turn-signal to the wheel-well, or something like that?...

 

ahh I guess I might be a 96... It's a recontructed title and I can tell the vin was put on because the vin states it's a 4 door and it's definitely a 2 door lol thanks guys I like the longer turn signals anyways 😄

 

Correction it's deff a 95 because of the tail lights I don't have any light pieces on the truck so they might just have put the 96 front bumper on it then.

 

There are three spots to check the VIN.
Doorjamb sticker.(can be pulled off or easily destroyed)
Dashpad VIN.(seen through the windshield)
Firewall stamped VIN (harder to see if the engine bay is dirty) the most likely one to be what the car actually is.

 

Lol! You got a Mr. Potato Head car! Jk man... Definitely do like MAD MIKE said and check those VIN's. This happens a lot where you'll get a Honda with mixed/matched parts. And don't forget that these 90's Hondas are quite high on the "most commonly stolen vehicles" lists so it's VERY possible that you could have chop-shop rebuild with a legit VIN#?
I gotta agree with you on the longer turn signals... The 96-97 bumpers look way better.