I am looking to sell my just recently built B18C1 block. This was my personal so everything has been taken care with it. Block has very low miles, id estimate 1500 or less. 81.5mm bore 13:1 cr IB Spec Wiseco pistons, Eagle H Beam rods, crank was balanced and polished, ACL bearings. Including a Comptech 9lb aluminum flywheel and a CTR N1 crank pulley. Total parts and labor for this project was more than $3000 plus, contact me for asking price, thanks.


Modified by PreStaged12s at 11:00 PM 4/13/2005

 

I am curious in this "extrude hone".....did u have this actual company perform this procedure.... http://www.extrudehone.com ? when they hone the head do they polish more than just the ports or what exactly makes this better than the average port/polish. u have any pics showing the head?

 

From what I understand Extrude Honing is a process in which "they" send a liquid that has fine particles in it through the head at a very high speed and the small particles in the fluid sculpt the head the way the fluid wants to flow the best.

Bump for a badass sounding motor

 

I ammended the original post, sorry for any confusion


Modified by PreStaged12s at 11:01 PM 4/13/2005