Testing 3 bar map sensor..
Thread Starter
Joined: Nov 2003
Posts: 639
Likes: 0
From: Stockbridge, GA
Testing 3 bar map sensor..
Ok- I tested my 3bar Map sensor According to hondatas website.
Specs say:
A/C - 5V
B/A - 1.6V
What My generic meter shows:
A/C - 4.96V
B/A - 1.55V
These voltages are very close to the specs, but I wasnt forsure if that one tiny little bit is bad or not.
Just need a heads up or not
Specs say:
A/C - 5V
B/A - 1.6V
What My generic meter shows:
A/C - 4.96V
B/A - 1.55V
These voltages are very close to the specs, but I wasnt forsure if that one tiny little bit is bad or not.
Just need a heads up or not
Honda-Tech Member
Joined: Aug 2001
Posts: 8,613
Likes: 1
From: Naples, Fl, USA
Re: Testing 3 bar map sensor.. (vtecluder97)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by vtecluder97 »</TD></TR><TR><TD CLASS="quote">Ok- I tested my 3bar Map sensor According to hondatas website.
Specs say:
A/C - 5V
B/A - 1.6V
What My generic meter shows:
A/C - 4.96V
B/A - 1.55V
These voltages are very close to the specs, but I wasnt forsure if that one tiny little bit is bad or not.
Just need a heads up or not</TD></TR></TABLE>
That fine
Specs say:
A/C - 5V
B/A - 1.6V
What My generic meter shows:
A/C - 4.96V
B/A - 1.55V
These voltages are very close to the specs, but I wasnt forsure if that one tiny little bit is bad or not.
Just need a heads up or not</TD></TR></TABLE>
That fine
Thread
Thread Starter
Forum
Replies
Last Post
null.
Forced Induction
6
Dec 15, 2005 06:35 PM
