The Beast gets a makeover..
#176
Honda-Tech Member
Thread Starter
Re: The Beast gets a makeover..
The accord has a bigger cv spline (36mm axle nut), and I have integra hubs in the rear.
As soon as I get a bit of free time and money, I'll have ALL the rear suspension together and installed, minus the coilovers. Idk what I'm going with as yet. It may not seem like it but the car is slowly coming together. I'll post pics when there is a solid update worth posting about.
Last edited by 88ED8; 05-10-2014 at 11:38 AM.
#177
Honda-Tech Member
Thread Starter
#178
Re: The Beast gets a makeover..
What's up man, Iam James from Cali. I have a swap that Iam 85% done with you think you can help me awd that baby ? I won't to do a f2k awd in honda integra 2 door my swap is done I seen this and I need this in my life can you help me?? I can post up pic but I don't know how to :-( new to this sit but not new street Raceing need parts and help
#180
Honda-Tech Member
Thread Starter
#182
Honda-Tech Member
Thread Starter
Re: The Beast gets a makeover..
#187
Honda-Tech Member
Thread Starter
#188
Re: The Beast gets a makeover..
This is killin me!!! What is going on with the Beast?? I know a project like this takes a bit of time. I started gathering parts for my AWD project almost a year ago. Got the trans in the car with the linkage set up and the rear trailing arms almost complete. I'll start working on mounting the rear diff and drive shaft soon. I love what you are doing with this thing. Keep on keepin on. One day...
#189
Honda-Tech Member
Thread Starter
Re: The Beast gets a makeover..
Anyways, I do work on it every once in a while, I haven't forgotten about it and it will be done one day! The rear end is about ready to be back on the ground, the cantilever suspension in the rear is complete. I'll focus on the front suspension and brakes next. Then the engine bay, body, and paint.... After the car is a car again and driving as FWD, I'll do the wheel alignment and all that will be left is the rear axles and drive shaft once i mount the diff.
#190
Re: The Beast gets a makeover..
Well, keep fighting the good fight! While I'm here, did you replace any of the bearings in the CRV rear diff while you had it apart? Looks like Honda didn't make these things very serviceable and there's about 5 bearings that could be replaced. Nothing in the manual about replacing them and no parts are listed on Honda's catalogue. Just wondering if you knew where to find new bearings for it.
#191
Honda-Tech Member
Thread Starter
Re: The Beast gets a makeover..
I replaced the two bearings on the diff. The other 3 I left alone. I got the diff bearings local from a place that sells things like that, called Bob Dean supply. koyo bearings 6207zzc3
#192
Thread
Thread Starter
Forum
Replies
Last Post
Unsung
Honda / Acura
33
09-14-2003 09:41 PM