Has anyone had problems with Competition Clutch twin disc grinding bell housing?
#1
Has anyone had problems with Competition Clutch twin disc grinding bell housing?
Tried to start my k series today and it wouldn’t crank over. Checked the starter and seems to be fine. Tried to spin the motor over manually and seemed kinda hard. I heard it slightly grinding from inside the bell housing area. Has anyone had this problem with competition Clutch twin disc grinding the bell housing? Probably just gonna end up pulling the swap out again and rechecking it but just wanted to see if anyone ran into this problem.
setup is k24 with Oem si tranny and competition Clutch twin disc with bearing that comes with it.
setup is k24 with Oem si tranny and competition Clutch twin disc with bearing that comes with it.
Thread
Thread Starter
Forum
Replies
Last Post