baggedd50

OBD1 B16a PR3-3 complete head minus intake, distributor, & vtec solenoid. Was pulled from a running motor with ~80k miles, will need to be hot tanked as it was sitting and is oil stained. There is also a nick on the metal edge where the cam caps meet the head, which can be seen in the picture. I was told the wouldn't affect anything, as it is only on the corner.

Asking 375 shipped to Cont. U.S.










81mm 10.5:1 comp CP piton with Eagle Rods. Piston have around 10k miles on them. The valves did kiss the pistons some, but were reused after wards without problem. You will have to buy another rod for one of the pistons, unless you can machine the scratches out out the connector which are drom a spun bearing. You will obviously need new rings as well.

Asking 300 shipped to Cont U.S.





















B16A Block, will need to be honed, mains are included. $100 pick up only





Only trades considered are Stage 3/4 clutch and fly wheel, or possibly a set of coil overs, maybe a set of 15'' rims if offered.

I'm Located in Baton Rouge, LA.

baggedd50

bump

baggedd50

ttt

baggedd50

Have a vtec solenoid I'll throw in with the head, though it's missing the plug.

baggedd50

yep

baggedd50

OBO

baggedd50

ttt

baggedd50

$275 shipped on the pistons, and I'll throw in the stock intake manifold for the head.

baggedd50

head is sold pending payment.

baggedd50

Buyer may have flaked on head. I will do 350 shipped for head, intake, vtec solenoid, and vc. 250 shipped for pistons.

baggedd50

Shoot me offers or something.....