OBD0-OBD1 Conversion, Crank but no start!?
#1
Honda-Tech Member
Thread Starter
Join Date: Nov 2010
Posts: 116
Likes: 0
Received 0 Likes
on
0 Posts
OBD0-OBD1 Conversion, Crank but no start!?
So I went about and bought a p28 OBD1 ECU, an obd0-obd1 Conversion ECU harness, and a obd1 Distributor, hooked it all up and all I get is cranking and electrical stuff to go on but no SPARK!
Prior to this, the last person who swapped it had a JDM PR3 VTEC ECU ,so all the VTEC and O2 Sensors are plugged into the old OBD0 Harness, could this be my problem? Theres a bunch of wires spliced and cut from the original OBD0 Harness, should I just connect my ground wires, VTEC, o2 sensor directly using the extra wires that my jumper came with?
I'm running oBd0 MPFI on 88 Hatchback
Prior to this, the last person who swapped it had a JDM PR3 VTEC ECU ,so all the VTEC and O2 Sensors are plugged into the old OBD0 Harness, could this be my problem? Theres a bunch of wires spliced and cut from the original OBD0 Harness, should I just connect my ground wires, VTEC, o2 sensor directly using the extra wires that my jumper came with?
I'm running oBd0 MPFI on 88 Hatchback
Thread
Thread Starter
Forum
Replies
Last Post
Pancho2193
Honda CRX / EF Civic (1988 - 1991)
5
03-04-2013 05:33 AM
dem0nk1d
Honda CRX / EF Civic (1988 - 1991)
32
09-15-2007 11:49 PM