View Full Version : Forced Induction
- Garrett t3/to4e ?
- Hadn't posted an update in a while.
- Where to get a copper headgasket?!
- Defi D gauge install confused please look...
- LS-V Turbo want to find a good turbo
- Over-rev my motor….. Bent Valves?
- Look at my plugs
- Why do I suck with the AVC-R?
- Race gas does wonders
- is it worth it...or even possible..
- which FPR with set-up?
- RC Injector Clip Install
- 99 civic ex going to convert to obd1 but until then what do i use for fuel managment??
- Turbine won't spin at idle! Blown turbo? Bad oil lines?
- Where to get Backdoor Intercoolers
- Colder plugs
- damn these orings!!
- AMS EVO Puts down 808 awhp (video inside)
- oilan fitting- cant find the right size
- Manual boost controllers
- piston clearance
- "Homemade" supercharger kits?
- my 11psi ignition timing map (picture), D16Z6, P28
- worst thing happened.. some one help me~!!!
- superchargers
- starting to put together my setup.
- ZC-T 1.6L DOHC Setups OBD-0/1 Specs/Dyno #'s
- fmu problem.
- Finally pulled apart my built b17... pros, please help me with these questions!
- Corrected or not corrected? Dyno info that might make sence......
- Fun times, Fun Times indeed......
- Remove engine or head???
- cutting down 60foot time?
- VAFC...acting a fool....anyone had this problem.
- SC61 turbine housing inlet smaller then my old SC44 inlet? what's the dealio?
- need trubo help
- very odd turbo problem
- What injector to purchase for my h22a setup??
- can't get more boost!!!
- a few sohc greddy turbo install questions
- modifying drag intercooler piping
- IC Piping Size
- Anybody make their entire engine harness custom made?
- what valve springs?
- How to stop td05-18g from spiking??????
- help me choose a turbo for mountain car
- 8-10 psi on stock b18a
- help ID this BOV
- Oil pump overkill..? Whats too much on a factory oil pump?
- If you can read this post you are cool!
- H23/VTEC build underway, final checklist.
- what turbo do i NEED...?????????
- Please experience/tech question, not for beginner thanks
- D16Y8 Turbo Hatch good or bad?
- Nitrous and propane? instead of fuel?
- What is the most effective cheap boost controller?
- After all the corrected and uncorrected convos....
- Reverse water flow through the block
- Thicker headgasket your opinion! yay or nay ?
- what does this civic got?
- external wastegate and o2 sensor question.
- turbo repair
- JRSC on B16a in a Del Sol
- need some help on 2000 integra ls turbo?
- Over sized valves
- Question on tuning...price
- going from copper to OEM HG: how will this effect my tune?
- Check this Intercooler Out...modded supra smic w/ welded end tanks...
- All motor B20 or force fed turbo B20?!?!?!?!?!
- lowering boost
- Suggestions for more power
- So im gonna be swapping out my lx engine and i dont know which way to go?
- Precision SC 50 Turbo... need info quick
- what kind turbo is this?
- Someone help me identify this Garrett turbo?
- thoriated tungsten
- 300whp possible??
- Just another "what size turbo thread"
- New to Turbos: Links to any informative threads
- 2000 miles on built motor still running NA--starting to sound like a Subaru
- Couple questions about reving a b16.
- wastegate dump-tube into downpipe ??
- Darton Block vs. Sleeving Block?
- fluidampr w/accessories vs. fluidampr w/o accessories poss close to 10k revs
- FPR Q
- The alternative to the inserts/rigid mounts for those who hate them. ( small write-up )
- Advice need on broken cam caps
- It's started, $7,000 out of my account today.
- Cheapest place to get a t3/t67 Fullrace turbo?
- 10 AN oilreturn line - what exactly does it mean?
- Manual boost controller?
- What Drag turbo kit for ek?gen3?
- 14 psi on stock internals?
- are drag manifold any good
- i found drag manifold are thet any good
- AVCR tech question
- do i need to upgrade fuel and ignition for turbo at low boost?
- Mase'd GSR 621 whp / 430 ft/lbs Street Car
- best turbo kit for sohc zc
- What Turbo should i use for my b18b1 setup
- new manifold install...charge piping question.
- V-Band For I/C Piping
- anybody know the part no. for the GM boost solenoid
- Quiet Turbo exhaust for a B16a DC4?
- Bracing the Turbo? (searched)
- HELP: what size is the oil drain flange on my precision sc61
- very hard time timing this motor with skunk2 cam gears
- bov
- Cams for Turbo H22
- What is THE best Electronic Boost controller. PERIOD.
- 84mm b16, t3t67 h.o. .70/.82 can gsr cams get me over 600 whp?
- Overkill??
- Need some help, car running like shit now...
- Turbo clocking and housing strength question
- Help!!! car wont rev past 2000 rpms
- K series Turbo Manifolds. DC5
- Precision GT35/61 ???
- Top mount turbo setup in EFs?
- Steering rack question
- GT series with a T25 based housing running an external wastegate?
- Fuel Pressure Drops? What could it be?
- 35mm Tial Spring ?
- more boost from greddy kit?
- b series manifold help???
- Im going LSV-T.. help
- Copy Cat of every major manifold...
- SOHC, what's better for 7 to 10 psi?
- Im finally done with my project... here is a small review.
- Apexi Power FC users! Need yr input here
- recommended max psi for b20?
- wideband questions
- built d16a6 stumbles a bit in top end...?
- Tuning a nitrous engine... optimal Air Fuel Ratio
- is it worth getting sleeves?...its my daily driver running on 91 octane
- Anyone using Blitz SBC i-color?
- Anyone w/pics of GT40
- How do I set my timing? 9:1 low compression pistons...
- New to turbo: need a honda-tech turbo lecture !!!!!!
- boostin my 94 integra
- vortech supercharger
- How to build an engine in less than 10 minutes...
- AEM EMS 1000cc Startup Issues
- question
- valve springs and retainers?
- max rev dp what manifold will fit
- choosing a wastegate
- choosing a turbo
- overfill oil on turbo cars...
- edelbrock Victor x intake manifold and stock cams
- is it safe to paint your intercooler
- D16Z6 DYNO GRAPH AND 121MPH TIME SLIP
- Bad track experience... Now my car sucks...
- Gotta T3/T4... and I want quicker spool! and do I need an FPR?
- This might be a long shot but..
- LS/VTEC SC61??
- DSM 450's on a 98 civic?
- will i need a turbo timer
- fuel pressure with boost
- Profec E-01's worthyness
- heating issues w/ sidewinder..
- Mild engine buildup - Need component suggestions
- Downpipe options ???
- delsol, turbo, b18a start then stop?????????????
- Gasket for turbo?
- turbo fitting
- what kinda clutch kit w flywheel.
- want to swap to MSD Ignition, what do i need?
- Anyone with 10psi JRSC GSR, can I see you dyno sheet?
- GReddy/Revhard Turbo Kit?
- D Series Intake Manifold and Throttlebody
- 650+whp k20a2
- Downpipe Bolt Which type to use?
- Not another Break-in question
- pricing turbo kits vs home made h22
- ecu issue?
- RC 550 saturated
- What setup?
- A few Q's on Darton MID sleeves
- Hondata and Motorolla 2.5bar Map Sensor?
- tial bov flange..
- Reading EGT
- b18block/b16head
- Boost HX or Mini me
- t3/t67 wich one?street car!!!
- Ls turbo or Type R?
- Boosted B18b Recently Dying. Need help PLEASE!!
- type r ecu
- does the turbo matter?
- can i drive my turbo'd civic with no charge piping on???
- Low boost system, couple questions.
- What should I expect?
- exhaust
- Need some quick help
- Best cams for turbo??
- help with turbo install.
- Edelbrock Nitrous Question
- For a LS-T, witch tranny use?
- y7 turbo...CEL help please
- Bov q?
- controlling fuel
- 3-bar map sensor with stock ecu
- Inline Pro Manifold capable of 500whp+?
- Someone have the AEM v1.11 upgrade file?
- Part Number Lookup
- Has anyone used a Cable Operated Exhaust Cutout. ?
- 20psi on pump 93
- Inlinepro/GT30 or 35 fitment
- missing link + blue box
- Crank Fluctuation Question
- All in One gauges??
- added s300 *dyno chart*
- I NEED A 5BAR map
- Theoretical D-series intake (pipe) size?
- how big of an overbore could i go without sleeving the block???
- Tried search
- <<<<< WHAT KIND OF GUAGES >>>>> HELP
- running rich at idle on hack
- 750cc holley's....losing injector?
- anyone with a Supercharged d16z6?
- my next project
- H22A EG6 Turbo Setup?
- Pic Request: Oil return line and setups w/ Spoolin perfomance AC manifolds.
- injector confusion
- Northern NJ Area Reputable Shop for building a K20
- In search for gaskets.....HELP!!!
- Apexi Turbo Timer setting up
- tial replacement springs
- will setting boost controller to zero psi do any harm?
- boost leak?
- Intake Manifold: Full Race/GE/Carbon Fiber
- Password Powerchamber and Nitrous
- DSM 450 injector ???
- Check out my setup....see if i should go with it
- Calling Turbo Gurus! Need opinions on this kit. Plz look.
- reliable turbo gsr on stock sleeves?
- has any one ever done or seen a front mount on a vortech kit?
- Who runs an ACT MaxExtreme in a cable trans. ??
- Launch controller (msd, chipped ecu, whatever)
- turboing a b18 gsr
- t25 feed and return??
- ls turbo
- oil in my charge pipe.....
- Is it possible to change piston/rods without taking engine out of the car?
- Blox Type-A Cams w/ Turbo
- sc61 housing pics..
- ?!?!? Cracked Exhuast housing on Tubonetics t3/t4 ?!?!
- GOIN TURBO and need some HELP
- oil lines to the turbo & oil pressure gauge..... Do I need to bleed them first?
- turbo area makes noise
- Fuel pump, fuel pressure regulator, or fuel rail needed for my turbo set-up?