Problems with JDM B18C GSR swap in EK
#1
Thread Starter
Join Date: Nov 2001
Location: St. catharines, Ontario, Canada
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Problems with JDM B18C GSR swap in EK
Hi there, i just recently finished up my OBD1 JDM B18C swap into my 97 cx hatch. I'm using a 98 CTR computer to run it, it's just temporary until my OBD2 to OBD1 harness comes in. When i start it up no matter whether it's hot or cold it starts idleing at about 1000 then it gradually rises in about 2 steps and idles at 2000. the idle will not come down, it's also running very rich. the other problem i have is that when i put a jumper on the clip to check the codes the CEL doesn't flash it just stays on. I've triple checked my wirring and it all seems to be in order. I can barely drive the car because at about 3 grand the engine just bogs and looses all power. If you guys have any ideas i'd love to hear them.
TIA
Mike
TIA
Mike
#3
Honda-Tech Member
Join Date: Oct 2001
Location: Dublin, CA
Posts: 463
Likes: 0
Received 0 Likes
on
0 Posts
Re: Problems with JDM B18C GSR swap in EK (crx-mike)
https://honda-tech.com/zerothread?id=493640
coordinate with/PM him to see if u two can figure anything out..
coordinate with/PM him to see if u two can figure anything out..
Thread
Thread Starter
Forum
Replies
Last Post
martiniracing
Honda Civic / Del Sol (1992 - 2000)
21
12-05-2009 10:55 PM
luvcivics
Honda Civic / Del Sol (1992 - 2000)
8
09-09-2007 10:21 PM
97GSRCivic
Honda Civic / Del Sol (1992 - 2000)
10
06-19-2007 06:54 PM