PR3 pistons and rods in a B18B1
03-17-2011, 09:36 PM
#1
Trial User
Thread Starter
Join Date: Mar 2011
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
PR3 pistons and rods in a B18B1
My question is does anyone here know if PR3 pistons and rods will work in a
B18B1. Now I know the are shorter in length by a little bit but with pistons being high compression will it work out to be a good compression ratio for a all motor setup or will it be to low for all motor. Thanks in advance if anyone has tried this setup before.
B18B1. Now I know the are shorter in length by a little bit but with pistons being high compression will it work out to be a good compression ratio for a all motor setup or will it be to low for all motor. Thanks in advance if anyone has tried this setup before.
Thread
Thread Starter
Forum
Replies
Last Post
