mounting non-atts tranny to atts block *searched*
02-05-2004, 07:25 PM
#1
Member
Thread Starter
Join Date: Mar 2003
Location: Wichita, KS
Posts: 3,689
Likes: 0
Received 0 Likes
on
0 Posts
mounting non-atts tranny to atts block *searched*
Can someone show me where I can find the bracket that allows the mounting of a non-atts tranny to an atts block or how to make one myself. If there is a thread out there then please link me. Thanx.
02-08-2004, 08:24 PM
#4
Honda-Tech Member
Re: mounting non-atts tranny to atts block *searched* (uncle)
There is no way to mount the Accord or Prelude intermediate shaft to the back of the ATTS block. You could use a one piece axle like the one found on the automatic transmission Accords.
If you use the ATTS unit but don't hook it up, it will act like a differential. That's its fail safe mode. I would loop the cooling lines since it probably pumps while it works. I'm not sure how long the ATTS unit will last doing this.
brian g
If you use the ATTS unit but don't hook it up, it will act like a differential. That's its fail safe mode. I would loop the cooling lines since it probably pumps while it works. I'm not sure how long the ATTS unit will last doing this.
brian g
Thread
Thread Starter
Forum
Replies
Last Post
B19CivicHB
Honda Accord (1990 - 2002)
2
03-18-2003 06:07 PM
