K series in my Accord
#1
Honda-Tech Member
Thread Starter
Join Date: Mar 2004
Location: PA, USA
Posts: 565
Likes: 0
Received 0 Likes
on
0 Posts
K series in my Accord
I really want to swap a K series into my 96 Accord, but I'm just not sure with setup I want to go with. My original plan was a K24A2 block topped off with a K20A head. But there will be so much customization and the bill will go from real expensive to really really expensive. I thought maybe I could just use the complete K20A from a CL7 Euro R, But I'm not sure if the K20A will have enough torque to push my beast of a car, that's why I was originally opting for the K24A2 block. Is the K20A from the Euro R the same K20A found in the DC5R?
<U>I have been searching and researching this topic, I am not asking you guys to make a decision for me, I am just looking for your mature opinion.</U> Thanks
<U>I have been searching and researching this topic, I am not asking you guys to make a decision for me, I am just looking for your mature opinion.</U> Thanks
#2
Honda-Tech Member
Join Date: Dec 2004
Location: PA
Posts: 4,126
Likes: 0
Received 0 Likes
on
0 Posts
Re: K series in my Accord (AccordCD5)
Well last I heard Hasport was still developing there mounts. Your looking at around at least $8k and thats if you find some good deals. Your best resource would be this site.
http://www.k20a.org
They are dedicated to the K swap
http://www.k20a.org
They are dedicated to the K swap
Thread
Thread Starter
Forum
Replies
Last Post