Just Completed A ZC Swap... Code 4 & 8
02-27-2006, 08:09 PM
#1
Honda-Tech Member
Thread Starter
Join Date: Nov 2004
Location: CORPUS CHRISTI, TX, USA
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
Just Completed A ZC Swap... Code 4 & 8
Just dropped in a ZC into a 90 CRX Si. The car starts, runs/revs normal for about 30 seconds, then starts spittin and Sputtering. Its throwing codes 4 and 8. Also, im running a PM-6. And ideas what it might be would be helpful.
Thanks everyone.
Thanks everyone.
02-28-2006, 06:16 PM
#4
Honda-Tech Member
Thread Starter
Join Date: Nov 2004
Location: CORPUS CHRISTI, TX, USA
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
Re: (2point2)
Very good "Captain Obvious". Since it has the CK sensor on the exhaust cam, can this be my problem, or is it going to be an internal problem in the distributor?
03-04-2006, 06:42 PM
#5
Honda-Tech Member
iTrader: (1)
Join Date: Aug 2005
Location: at the shop
Posts: 5,831
Likes: 0
Received 0 Likes
on
0 Posts
Re: (DEADLYACURACCY)
zc tend to have a problem with these cam sensors i have one for sale i also have a dizzy to just pm me i had nothin but problems with my zc thats why i am goin VTEC
03-04-2006, 06:44 PM
#6
Honda-Tech Member
iTrader: (1)
Join Date: Aug 2005
Location: at the shop
Posts: 5,831
Likes: 0
Received 0 Likes
on
0 Posts
Re: (pitbullracer)
also have a pg7 for sale but how does it run when reved up like 55-6 mine would bog out at high rpms kinda like a misfire it was dizzy
03-09-2006, 04:57 PM
#7
Join Date: Feb 2006
Location: corpus christi, Texas, USA
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Re: (pitbullracer)
ok we got it fixed with a new 1991 integra disributor and it work's great, code gone thanks for all the input. My rev it up to 7200 before it top out.
Thread
Thread Starter
Forum
Replies
Last Post
