2.3h2b

Car is finally done thouth I'll share it
setup
Stock f20b auto long block
pro2s
super tech retainers
68mm skunk2 port matched
port & polished p13 manifold
440cc rb skyline intecters at 78% capacity
PWjdm carbon intake
pLM header
2.5 exhaust no cat to a obx twin loop muffler
tune on a p28 with s300
EVOLUTION ind H2B kit
b16 trans with a Six puck clutch
sk2 cluster
185whp was before the plm header an ported manifold

2.3h2b

sk2 cluster

1991_crxsi

iTrader: (1)

Super clean swap, and nice graph. That EG looks nice on those fat fives, and the s2k cluster is sweet. Now I got to post my build thread lol.

2.3h2b

thanks bro I'm thinking of what to do next out of either tune on e85,shorter FD or LSD,tune with a 60ish shot wet fogger a buddie is selling me new kit for 300 with out the bottle or paint the car

2.3h2b

other cars that hit the dyno are
built b20v 150whp
fully built b16 only thing stock were cams 136whp
bolt on with CP tune MS3 227whp/260ft tq
stock b16 Greedy kit 7 pounds 200whp

to name a few

1991_crxsi

iTrader: (1)

Sounds like that dyno is off. Stock B16 on that Greddy kit at 7lbs should be around 240ish I think. Built B20V built mildly would still make over 180 whp. Plus the videos of your EG look a bit stronger than 200 WHP. Either way, I love that car. Thumbs up for rocking the F20B and dusting Evos.

AznVato

very nice swap! did u have any clearance issues with the tensioner?

2.3h2b

you might be right dyno does seem a little off.I ran a ms3 unknown mods from a stop half way down the 1/4 mile 5 cars ahead.I also ran a evo8 unknown mods but way quicker then the evo10 I beat ran that on the long stretch I won by a car but it was quick.Car revs high a 4.7 or 4.9 might be a better match for those 9k shifts.b16 4.4 is perfect for a car like yours with that 2.3 liter you have that makes power lower.

2.3h2b

thanks I'm glad you like it

Clearance issues I had were alternater, an the block an oil pan were barely in the way of the axles needed a little nudging.

wutthebun

iTrader: (2)

no hood clearance issues? looks like your hood closes nice & tight....

2.3h2b

it closes perfect with the EVO kit

DocB_Ek6_f20b

What wire harness did you use ?? I have a f20b in a 96 coupe and I can't seem to find a harness to match ??

2.3h2b

Ob1 single cam harness you will need to extend the length of the pig tails for the h"f" series motor and modify some plugs.

DocB_Ek6_f20b

Thanks