EG B18C Wiring with ECU Jumper Harness
#1
Honda-Tech Member
Thread Starter
Join Date: Jan 2003
Location: Atlanta, GA
Posts: 287
Likes: 0
Received 0 Likes
on
0 Posts
EG B18C Wiring with ECU Jumper Harness
Perhaps an elementary question, but here goes:
Motor to be swapped: OBD2 JDM B18C (year 1998)
Vehicle to receive swap: 1994 EG Hatch SI
I'm going to use the JDM OBD2 ECU.
My question is regarding the wiring for the knock sensor and IABs: when using a jumper harness to use an OBD2 ECU in an OBD1 car, will I run the wires to the original ECU plugs in the cabin or to the end of the jumper harness that's actually plugged into the ECU?
Thanks in advance.
Sean
Motor to be swapped: OBD2 JDM B18C (year 1998)
Vehicle to receive swap: 1994 EG Hatch SI
I'm going to use the JDM OBD2 ECU.
My question is regarding the wiring for the knock sensor and IABs: when using a jumper harness to use an OBD2 ECU in an OBD1 car, will I run the wires to the original ECU plugs in the cabin or to the end of the jumper harness that's actually plugged into the ECU?
Thanks in advance.
Sean
Thread
Thread Starter
Forum
Replies
Last Post
JimmiMorris
Honda Civic / Del Sol (1992 - 2000)
7
01-24-2012 04:25 PM
jdmchickx
Honda Civic / Del Sol (1992 - 2000)
10
10-26-2011 06:03 PM
hybrid_eg
Honda Civic / Del Sol (1992 - 2000)
8
10-20-2003 11:32 AM