ctownintegra

Will be picking up the tranny Monday....any suggestions or tips for problems i might run into.. I'm installing ES Motor mount inserts tomorrow and starting on pulling the tranny. Any parts need replacing? How high up will the car have to be? Can 2 people tackle it? Thanks for any advice.

JDM JEFFREY

iTrader: (1)

two people will be fine. I would replace the clutch and flywheel now that you have the tranny off, but that's about all.

ctownintegra

Went to pull the tranny out and have ran intoa million and one problems....the axle is still mouned to the hub and is in the way, the tranny wont seperate from the black, when we pulled the passenger axle out of the tranny 3 bearings came out.....why will it not separate?

radteg

what are u using to separate it?sometimes it is snugg on there.replace everything that u can...in the long run u will be happy with having good parts.

ctownintegra

Got it out, new tranny going in thursday with ACT Streetlite flywheel and clutch....can't wait to get it back on the road.

radteg

good to hear...yeah i know what u mean. a lot of ppl get all caught up and just want it to run again and don't take there time and get everything right when they have the chance too.

. o 69 o .

don't forget the change the release bearing, also, be sure to break it in properly or you'll have nothing but a glazed clutch

ctownintegra

Yep....300 miles of babying it....I'll probably do 500 to be safe...then I'm headed to the strip...

. o 69 o .

every 40 miles increase the rpms by 1000... starting out, dont rev past 3500rpms