50mm vs 55mm mains
01-01-2012, 11:42 AM
#1
Honda-Tech Member
Thread Starter
Join Date: Feb 2004
Location: Minnesota
Posts: 383
Likes: 0
Received 0 Likes
on
0 Posts
50mm vs 55mm mains
I'm currently using a f22 crank with 50mains, made decent numbers but was thinking was thinking about going with a 97mm crank
From what i understand F23 have 97mm stroke but the mains are 55mm.
If i can't find a +97 h22 block, i'll have to use one of my spare usdm h22 blocks.
Q:
1) Does anyone have DIRECT experiance with using F23 (55mm mains) in >96 h22 motors?
2) Using a >96 H22, would I it be as simple as taking the block with the mains TORQUED down and then line bored to 55mm?
I just seems like everyone is avoiding it just because of this issue but in for me it seems just strait forward.
From what i understand F23 have 97mm stroke but the mains are 55mm.
If i can't find a +97 h22 block, i'll have to use one of my spare usdm h22 blocks.
Q:
1) Does anyone have DIRECT experiance with using F23 (55mm mains) in >96 h22 motors?
2) Using a >96 H22, would I it be as simple as taking the block with the mains TORQUED down and then line bored to 55mm?
I just seems like everyone is avoiding it just because of this issue but in for me it seems just strait forward.
01-01-2012, 11:53 AM
#2
Re: 50mm vs 55mm mains
I'm currently using a f22 crank with 50mains, made decent numbers but was thinking was thinking about going with a 97mm crank
From what i understand F23 have 97mm stroke but the mains are 55mm.
If i can't find a +97 h22 block, i'll have to use one of my spare usdm h22 blocks.
Q:
1) Does anyone have DIRECT experiance with using F23 (55mm mains) in >96 h22 motors?
2) Using a >96 H22, would I it be as simple as taking the block with the mains TORQUED down and then line bored to 55mm?
I just seems like everyone is avoiding it just because of this issue but in for me it seems just strait forward.
From what i understand F23 have 97mm stroke but the mains are 55mm.
If i can't find a +97 h22 block, i'll have to use one of my spare usdm h22 blocks.
Q:
1) Does anyone have DIRECT experiance with using F23 (55mm mains) in >96 h22 motors?
2) Using a >96 H22, would I it be as simple as taking the block with the mains TORQUED down and then line bored to 55mm?
I just seems like everyone is avoiding it just because of this issue but in for me it seems just strait forward.
I do what do I need to know pm me
Thread
Thread Starter
Forum
Replies
Last Post
