journeyquest

D15B2.Anyone use one of the aftermarket head gasket sets that are sold online for around 50 bucks? Graphite head gasket, intake, exhaust ect.

DumpdEJ6

Cheap intake, exhaust, and valve cover gaskets are ok IMO, but I wouldn't skimp on the head gasket. Get a quality Multi Layer Steel one if you can.

crxmadness

OEM only, unless u want to do the job twice and have a lot of headaches

EL Vap133

Agreed!

BlendedEM1

I used a gasket from autozone and so far it is working just fine

rpmraper

not to steal your post, but i also have a head gasket question.. whats a good one that will lower compression a bit, z6 block y8 head..

zrickety

iTrader: (1)

i would recommend a felpro set at least...

1990edsedan

I've used felpro for the past few years, no failures.

spcrxracer

iTrader: (1)

I don't skimp on any gaskets. OEM Honda all the way. Especially after I price compared and the prices at my dealer are the same or better than any third party manufacturer.

The only felpro gasket I've ever used is intake and exhaust manifold gaskets.

journeyquest

Thanks. I just ordered the Felpro set off of Amazon. Cost one bill. I have had very good luck with Felpro over the years with my Chevys.