Phoenix_ITR

iTrader: (1)

hey guys -- pretty simple question:

i'm putting a b16 (most likely an A2) into my 95 dx coupe. I'll be running hondata s300 on a p28 ecu.

I need to know if the rywire subharness linked below will take care of all my car-side wiring issues. Do i need to add anything aside from VTEC and VTEC oil pressure wiring? I know the p28 ECU does not have provisions for a knock sensor...
also if i use this pre-made subharness, will i run into any issues running a pre-OBD 2 motor if i end up going that route?

someone please help me out here...

http://rywire.com/store/9295-c...972f5

jax97hx

Yes it appears that will do it for you. s300 will also help with and problems u might have.

EGJason

The 95 DX is wired for OBD1 Non-VTEC. That harness is all you need for OBD1 or OBD2

Phoenix_ITR

iTrader: (1)

thanks for the help.