ion_four

I have a 93 Civic EX Coupe with the 10.3" discs up front and am in the process of converting the rear to discs from a 95 Integra...can someone verify the thread size and pitch for the front and rear bleeders? Is it 10mm x 1.0mm (front) and 10mm x 1.25mm (rear)? I couldn't find the 1.25mm pitch in the autoparts store...(if that's even it)

NOSpeed97

FRONT 93-95 Civic EX (w/o ABS) = 10mm x 1.25

REAR 94-99 Integra = 8mm x 1.25mm

From:
http://www.russellperformance.com/au...ers_import.htm
http://www.russellperformance.com/au...d_bleeders.htm

I used a Russell Speed Bleeder at each one my four calipers. It's a good investment.

ion_four

hmm, I didn't think it was that small (8 x 1.25)...it really seems like they are 10mm. that's the size of the head, and the 10 x 1.5 that I got don't quite thread. maybe I'm wrong. I'll have to look again.

Thanks for the info, though!

ion_four

holy crappo...
can someone tell me if the 90-93 integras came with ABS? According to the sizing guide for bleeders on the russell site, I have calipers for that era, as opposed to 94-99?! ****-*****, I hope I didn't really **** myself here...I am 99% sure they're from a 95 Integra GSR...but, it was gutted like a fish, so I can't be 100% sure...arrrrgh (I hope I'm not THIS dumb)

mrlegoman

Both the fronts and rears will need the 10x125
(see sig below)

ion_four

crappy...I bought the ones that the russel site says I need...I hope they're right! It said the front was 8mm, I think...

jaymar88

I ordered a set through don. Excellent service.It only take me about 5 mins to bleed all four corners.

mrlegoman

Don't sweat. The thread pitch is the same. If Russel says 8mm, then I would think they should work. I'll try to find a pic of what the 10mm's look like on my GSR brakes. If there is more than a 2mm clearence on the 10's, then the 8mm's will work fine.


[Modified by mrlegoman, 7:43 PM 1/27/2003]